Deephaven, MN is a city that is well known for having poor water quality. Private well owners constantly battle with high levels of iron, hydrogen sulfide, water hardness, and even arsenic.

Old Iron Filter System

We first serviced our clients in 2007 by replacing an old softener with a new high efficiency Hague WaterMax softener. This system improved water pressure and used 70% less salt than their old Fleck water softener.

The existing 10” x 47” iron filter was in bad shape, and had been partially disabled by other sub contractors over the years. At the homeowner’s request, we re-built the control head and added a new air relief valve to try and get this system to “limp along”.

By October, 2009 the old iron filter was failing again. The rust stains and rotten egg smell were starting to take it’s toll on the plumbing, water softener AND the homeowner. It was time for a real iron filter system:

“We just COULD NOT get the iron and odor filtered out of the water for a constant, clean water supply. We wanted water that was always clean, odor-free and soft. We wanted a solution that would work.”

Why the Previous Iron Filter System Failed:

- Inadequate Iron and Hydrogen sulfide capacity

- Iron and Hydrogen Sulfide were not completely oxidized

- Undersized filter vessel only provided 2.7gpm (gallons per minute) flow (enough for 1 faucet)

- Iron-clogged plumbing reduced the filter’s backwash ability (clean itself)

- Frequent power outages constantly disrupted the filter’s settings

New Iron Filter System

The Premier Water Solution:
The old ¾” copper was replaced with new 1” copper for less restriction and improved backwashing (cleaning) ability. We used a Hellenbrand Iron Curtain system with a 13”x54” dedicated aeration tank was used to pre-treat the water and oxidize the iron and hydrogen sulfide for better filtration. A 13”x54” vessel using vertical depth filtration replaced the small 10” filter to handle heavier water flow rate needs up to 8gpm.

A special distributor was also used to reduce waste water by 30% over the old system. A digital controller runs the system and holds all settings up to 2 ½ years during power loss to combat the frequent power outages here.

The new system completely eliminated the rust stains and odor problems, the softener now works more efficiently, and waste water was reduced. The results speak for themselves:

My freshly washed clothes now smell like a clean fresh load of laundry. Brushing my teeth is no longer a gross experience with smelly water.

Your staff worked very hard to solve our water issues, and truly care about customer satisfaction.

Initial Results:
System Flow Rate: 2.7gpm
Iron Bleed-Through: 6ppm*

Final Results:
System Flow Rate: 8.0gpm
Iron Bleed-Through: 0ppm*

*0.3ppm is the iron limit before staining begins

Click Here to Download this Case Study